Gates is a working neighborhood of 1950s and 1960s ranches and capes built light and fast, with thin attics that bake in July and freeze solid every January when lake-effect snow piles up off Ontario. Your home sits on a basement, probably concrete block or old sandstone, and that basement sweats in spring and summer while your attic pulls heat out through every gap and seam.
Homeowners in Gates call Rochester Spray Foam Insulation because we know the problem: a heating bill that climbs every winter, a bedroom that never gets warm, and condensation or damp insulation in the attic that shows up after the first heavy snow. We have been serving Gates and the Rochester area since 2012, and we fix what drafts and thin insulation break.
Spray Foam Insulation in Gates (14624)
Your 1950s or 1960s ranch or cape was built to a budget, not to a performance standard. The attic is shallow, the rim joists are exposed to the basement, and the original insulation, if there is any, has settled or compacted into a thin blanket that stops almost nothing. Lake Ontario wind finds every gap. Heavy snow loads in January drive moisture into the attic. Summer humidity pushes vapor up through the floor, and by March your insulation is damp and the sheathing is soft.
Spray foam stops all of it. Closed cell foam is dense enough to hold moisture out and to carry structural load. Open cell foam breathes and costs less, and it is the right choice for attics that need to stay dry and for walls that have to manage vapor from both sides. We size the foam by thickness and R-value, specify it in writing, and install it with mechanical ventilation during cure so you can re-enter the space safely in twenty-four to forty-eight hours. Our team is fully insured with general liability and workers' compensation coverage.
Our services in Gates
- Attic Spray Foam Insulation in Gates · Open-cell foam on the roof deck turns a Rochester attic that builds ice dams…
- Closed Cell Spray Foam Insulation in Gates · Two-pound closed-cell foam delivers R-6.5 per inch with its own vapor retarder…
- Open Cell Spray Foam Insulation in Gates · Half-pound open-cell foam air-seals attics and walls at a friendlier price per…
- Wall & Injection Foam Insulation in Gates · Injection foam fills closed walls through small drilled ports, no demolition.
- Crawl Space Spray Foam Insulation in Gates · Closed-cell foam on crawl spaces under kitchen additions and sunrooms ends cold…
- Rim Joist & Band Joist Spray Foam in Gates · Basement rim joists leak more cold air than almost anything in a Rochester…
- Garage Spray Foam Insulation in Gates · Garage ceilings under bonus rooms and shared walls are foam-sealed against July…
- Metal Building & Barndominium Spray Foam in Gates · Closed-cell foam stops a New York pole barn from sweating in spring and…
- Commercial & New Construction Spray Foam in Gates · Warehouses; offices; churches and production builders served on schedule.
- Insulation Removal in Gates · Old blown-in and batts vacuumed out before any new foam goes in, never buried.
- Insulation Replacement & Re-Insulation in Gates · The full reset: old material removed; gaps air-sealed…
- Air Sealing in Gates · Top plates, can lights, chimney chases and attic hatches leak the warm air that…
How a Job Works in Gates
We start with a free on-site assessment. We walk your attic, crawl space, or garage, measure what we see, and explain what needs to come out and what stays. We answer your questions and send you a written estimate with the R-value, thickness, and square footage or board footage specified so you know exactly what you are paying for and what you are getting.
On the day of the job, we set up mechanical ventilation and protect your belongings. We spray the foam in controlled passes, hold the thickness and ratio that the manufacturer requires, and let the material cure. If insulation has to come out first (wet, contaminated, or failed), we remove it and haul it away. If the substrate is wet or leaking, we stop and tell you what has to be fixed first. We do not spray over problems; we fix the moisture first or we walk away.
When the work is done, we clean up, remove the ventilation, and walk through with you. Your attic or crawl space is ready to use, and your home is tighter and warmer.
Attic spray foam in Gates typically runs from $1.50 per square foot for open cell to $1.20 per board foot for closed cell, depending on thickness and R-value. A 1,000-square-foot attic with six inches of closed cell foam is usually between $3,000 and $5,000. Rim joist and band joist work starts around $650. Crawl space encapsulation with foam starts at $2,500. Insulation removal runs from $950, and full insulation replacement starts at $2,800. The actual price depends on the area to cover, the R-value you need, what has to come out first, and how tight the access is. Call us at (585) 565-5602 for a free estimate. We measure on site, give you a number in writing, and do not surprise you.
✅ Written Estimates with R-Value & Thickness Specs, fully insured for work in Gates and nearby areas.
